Husqvarna AR19 Bedienungsanleitung PDF herunterladen (Seite 42)

40 – English

LUBRICATION

2. Oil change in reduction gear 1:6

The engine’s reduction axle does not have a

drainage screw, but the oil can be drained through

the level plug hole (2) by tipping the machine

forward. Because it is difficult to avoid spilling

gasoline and releasing gasoline fumes, the oil

should not be changed indoors.

1. Empty the fuel tank or put a vessel in place to

collect gasoline spills.

2. Tip the machine forwards, place a vessel

under the level plug (2) and remove the filler

plug (1) and the level plug (2)

3. Allow the engine oil to drain into the vessel,

right the machine and park it on even ground.

4. Refill using new oil of the same type as that in

the engine in the filler hole until it runs over

from the level plug. Volume 0.15 liters.

5. Replace the level and filler plugs. Tighten them

moderately.

6. Wipe up any spilled oil.

Checking the gearbox oil level

Make sure the machine is parked on even ground

and that the engine is not running. Carefully remove

the level plug (2) and check that oil drains out. If

there is no oil leakage, the machine can be carefully

tipped forward to estimate the oil level. If necessary,

fill the oil in the filler plug hole (1) until it runs over

from the level plug.

Replace the level and filler plugs. Tighten

moderately.

IMPORTANT INFORMATION

Used engine oil is a health hazard and

legislation prohibits disposal on the ground or

in nature; it should always be disposed of at a

workshop or appropriate disposal location.

Avoid skin contact; wash with soap and water

in case of spills.

Checking the engine’s oil level.

Make sure that the machine is parked on even

ground with the engine stopped when checking the

oil level.

1. Unscrew the dipstick and wipe it using paper

towel or a lint-free rag.

2. Replace the dipstick without screwing it in.

Remove and check the level on the dipstick.

3. Fill oil as necessary to the lip of the dipstick

hole. Oil type, see chapter ”Lubrication/1. Engine

oil”.

4. Check that the rubber gasket is in position and

screw the dipstick back into place. Do not

tighten it askew or too hard or you may damage

the threads.

8011-055

8011-020

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 55 56

Kommentare zu diesen Handbüchern

Keine Kommentare

Husqvarna AR19 Bedienungsanleitung Seite 42

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Werkzeug Husqvarna AR19