Husqvarna AR19 Bedienungsanleitung PDF herunterladen (Seite 46)

44 – English

ASSEMBLY INSTRUCTIONS

Applies to model AR25.

1. Use eye protection. Remove the wooden blocks.

IMPORTANT INFORMATION

Be careful for nails and slivers.

2. Carefully cut along the side of the box.

3. The lawn aerator is delivered with the handle

removed. Fit the handle using two wrenches

(13 mm).

4. Slide the handle onto the mountings (see the

top illustration). Affix the handle on the

mountings using fittings A (see the bottom

illustration).

5. Fit the upper part of the control rod (3 on the top

illustration) to the rear wheel control (4 on the

top illustration) using fittings B (see the bottom

illustration).

6. Affix the lower part of the control rod to the

outer side of the torque arm mounting (1 on the

bottom illustration) using fittings C (see the

bottom illustration).

7. Connect the clutch cable by threading it

through the guide hole (6 on the top illustration)

at the back of the machine.

8. The lower end of the throttle cable (2) is factory-

installed. Insert it through the guide hole (8 in

the top illustration) and affix the spring for the

throttle/clutch (5 on the upper illustration).

9. Fill the engine with the manufacturer-

recommended oil. See the chapter ”Lubrication/

Engine oil”.

Fill the reduction gear with the manufacturer-

recommended oil. See the chapter ”Lubrication/

Oil change in reduction gear”. The machine

must be parked on level ground when inspecting

and filling oil.

10. Put the weights in the compartments on the

sides of the machine.

8011-075

8011-076

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 55 56

Keine Kommentare

Husqvarna AR19 Bedienungsanleitung Seite 46