16530-LSOperator's Manual
10TO CONTROL SNOW DISCHARGE (See Fig. 14)WARNING: Snow throwers have ex- posed rotating parts, which can cause severe injury from contact, or from ma-
11TO THROW SNOW (See Fig. 15)The auger rotation is controlled by the auger control lever located on the right side handle.• Squeeze auger control lev
12NOTE: It is not recommended to operate the snow thrower over gravel or rocky surfaces. Objects such as gravel, rocks or other debris, can easily be
13OPERATIONTO START ENGINE • Be sure fuel shut-off valve is in the “OPEN” position.Your snow thrower engine is equipped with both a 120 Volt A.C. ele
14LUBRICATION CHARTGENERAL REC OM MEN DA TIONSThe warranty on this snow thrower does not cover items that have been sub ject ed to operator abuse or n
15NOTE: Although multi-viscosity oils (5W30, 10W30 etc.) improve starting in cold weather, these multi-viscosity oils will result in increased oil co
16WARNING: To avoid serious injury, before per-forming any service or ad just ments:1. Be sure throttle is in STOP position.2. Remove safety ignition
171. REMOVE GASOLINE FROM FUEL TANK - Drain gaso-line from fuel tank into a suitable container, out doors, away from fire or flame. Wipe up any spill
18NOTE: To seal punctures or prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also preve
19Immediately prepare your snow thrower for storage at the end of the season or if the unit will not be used for 30 days or more.WARNING: Never store
2IMPORTANTSafe Operation Practices for Walk-Behind Snow ThrowersThis snow thrower is capable of amputating hands and feet and throwing objects.Failure
20TROUBLESHOOTINGDoes not start 1. Fuel shut-off valve (if so 1. Turn fuel shut-off valve to OPEN position. equipped) in OFF position. 2.
21Consumer Wheeled Products – Limited Warranty Husqvarna warrants to the original retail purchaser that this Husqvarna® product is free from defects i
22c. Preventative maintenance as outlined in the operator’s manual. In addition, you must cease using the product immediately upon any failure or dama
23Consumer Wheeled Warranty Chart 2010Exhibit AConsumer (personal,household use only)Commercial (any commercial, professional, institutional, arigcul
532 43 56-54 06.07.10 TH Printed in the U.S.A.Consumer Wheeled Warranty Chart 2010Exhibit AConsumer (personal,household use only)Commercial (any c
3CONGRATULATIONS on your purchase of a new snow thrower. It has been designed, engineered and man u -fac tured to give best possible dependability an
4(1) POWER CORD(198563)(1) DISCHARGE CHUTE(6) SHOULDERBOLT 1/4-20 x 1-3/4(192090)(1) WASHER 3/8(19131316)(1) LOCKNUT 5/16-18(751153)(1) CARRIAGE BOLT
5Read these instructions and this manual in its entirety before you attempt to assemble or operate your new snow thrower. Reading the entire manual w
6AUGERCONTROL RODCONTROL ARMRUBBER SLEEVELOOP OPENING UPFig. 5INSTALL TRACTION DRIVE CONTROL ROD(See Figs. 3 and 4)The traction drive control rod has
7INSTALL DISCHARGE CHUTE / CHUTE ROTATOR HEAD (See Fig. 7)NOTE: The multi-wrench provided in your parts bag may be used to install the chute rotator h
8KNOW YOUR SNOW THROWERREAD THIS OWNER'S MANUAL AND ALL SAFETY RULES BEFORE OPERATING YOUR SNOW THROWER. Compare the illustrations with your sno
9MEETS A.N.S.I. SAFETY REQUIREMENTSOur snow throwers conform to the standards of the American National Standards Institute.Drive speed control lever -
Kommentare zu diesen Handbüchern