Husqvarna 150BF Bedienungsanleitung

WARNINGThe engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive W

English10 1. Frame2. Harness3. Spark Plug Cap4. Throttle Lever5. Net6. Choke Lever7. Air Cleaner8. Volute Case, Cover9. “CAUTION” Label10. Elbow11.

English 111. Frame2. Harness3. Spark Plug Cap4. Throttle Lever5. Stop Switch (behind)6. Net 7. Choke Lever8. Air Cleaner9. Volute Case, Cove

English12 1. Frame2. Harness3. Spark Plug Cap4. Throttle Lever5. Stop Switch (behind)6. Net 7. Choke Lever8. Air Cleaner9. Volute Case, Cove

English 13• The data shown above are those in the case of one straight pipe.• Specifications are subject to change without notice.MODEL 130BT 150BT 1

English14 SWIVEL JOINT1. Connect the blower and swivel joint with flexible hose. Clamp both ends of the flexible hose securely with the hardware sup

English 15BLOWER TUBES1. Align the protrusion and the groove provided on the tube ends and twist the tube until the connection is locked.NOTEA light

English16 FUELWARNING• Gasoline is very flammable. Avoid smoking or bringing any flame or sparks near fuel. Make sure to stop the engine and allow i

English 17CONTROL ARM [150BF/170BF/180BF]• Hold the upper end of the control arm in hand and, while pulling it away from the unit, rotate arm forwar

English18 ADJUSTING IDLE SPEED[130BT]• The idling speed is set for 3000 rpm at the factory. If it is necessary to adjust the idle speed, use the adj

English 19Maintenance, replacement, or repair of the emission control device and systems may be performed by any non-road engine repair establishment

English2 YOUR WARRANTY RIGHTS AND OBLIGATIONSThe EPA (The US Environmental Protection Agency), CARB (California Air Resources Board), Environment Can

English20 [170BT/BF] [180BT/BF] (F31)1. Unscrew 2 knob bolts and remove the air cleaner cover. Then remove the prefilter mounted inside the air clean

English 21AIR INLET NETIMPORTANT• Blown air is taken in from the air inlet net. If the air flow drops during operation, stop the engine and inspect

22 130BT&180BT_US-65.fm Page 22 Friday, December 7, 2007 1:05 PM

English 3Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4SAFETY FIRST . . . . . . . . . . .

English4 SAFETY FIRSTInstructions contained in warnings within this manual and warning seals marked with a symbol on the blower concern critical po

English 5For safe operation and maintenance, symbols are carved in relief on the machine. Using to these indications, please be careful not to make a

English6 WORKING CONDITIONS1. Refrain from operating the blower if you are tired, ill, or upset, or if you are under the influence of alcohol, drugs

English 7BEFORE STARTING THE ENGINE• Each time before starting the engine, inspect the entire unit to see if every part is in good order and is secur

English8 MAINTENANCE1. In order to maintain your product in proper working order, perform the maintenance and checking operations described in the ma

English 91. Frame2. Harness3. Spark Plug Cap4. Throttle Lever5. Guard Net6. Choke Lever7. Air Cleaner8. Volute Case, Cover9. “CAUTION” Label